When storing stainless steel pipes, attention should be paid to moisture, dust, oil, lubricants, etc., as well as surface rust, or poor welding and reduced corrosion resistance. When moisture is immersed between the film and the steel plate base, the corrosion rate is faster than without the film. When storing in the warehouse, it should be placed in a clean, dry, and ventilated place, and the original packaging should be maintained. Storage: During storage, attention should be paid to moisture, dust, oil, lubricating oil, etc., as well as rust on the surface, or poor welding and reduced corrosion resistance. When moisture is immersed between the film and the steel plate base, the corrosion rate is faster than without the film. When stored in the warehouse, it should be placed in a clean, dry, and ventilated place, and the original packaging state should be maintained. The stainless steel with the film should be protected from direct light. The film should be inspected periodically. If the film deteriorates (the film has a lifespan of 6 months), it should be replaced immediately and padded. If the paper packaging material is soaked, the backing paper should be removed immediately to prevent surface corrosion. Transportation: During transportation, rubber or sleepers must be used to avoid surface scratches. Special stainless steel protection materials should be used as much as possible. To avoid surface contamination caused by fingerprints, gloves should be worn during operation. The surface rust or the corrosion resistance decreases due to poor welding. When moisture is immersed between the film and the steel plate base, the corrosion rate is faster than without the film. When stored in the warehouse, it should be placed in a clean, dry, and ventilated place, and the original packaging state should be maintained. The stainless steel with the film should be protected from direct light. The film should be inspected periodically. If the film deteriorates (the film has a lifespan of 6 months), it should be replaced immediately and padded. If the paper packaging material is soaked, the backing paper should be removed immediately to prevent surface corrosion.